Bilstein B4 Shock Absorbers 19-342016 – Cupra Formentor (KM7, KMP)
Hurry up, only 3 items left in stock.
Couldn't load pickup availability
Get €20 off when you spend €1,000 or more! Learn more
Fits these vehicles
- CUPRA FormentorKM7, KMP07/2020–FWD
Product Details
Product Details
Bilstein Rear (universal) shock absorber — Bilstein Shock Absorber 19-342016
Specifications
- Fitting Position: Rear (universal)
- Type: Gas Pressure
- Damping System: Twin-Tube
- Mounting: Bottom eye
Performance
B4 is Bilstein's OE-replacement damper: valving matched to the car's original specification so ride height, body control and comfort return to how the vehicle left the factory. Nothing is uprated and nothing is lowered — it is the right choice when worn dampers have made the car float, bounce or wander, and you want factory behaviour back rather than a firmer setup. This unit is twin-tube, the construction Bilstein specifies where the original fitment used it.
Fitment
Fits CUPRA Formentor (KM7, KMP), from 07/2020, FWD — see the full list below. Verify fitment using the vehicle compatibility checker above.
What's Included
One Bilstein B4 damper unit for the rear axle (either side) — a single shock absorber, not a pair and not an axle set. Order two to do an axle, four for the whole car. Mounting is bottom eye. Bump stops, dust covers, top mounts and fixings are not included.
Warranty
Backed by Bilstein's manufacturer warranty against defects in materials and workmanship. Cover assumes correct installation, the correct tightening torques, and serviceable bump stops and dust covers. A damper run without its protection parts will be scored by road grit — that is wear, not a defect. As an official reseller in the EU, Suspengo also handles your statutory conformity rights on this purchase — contact us first and we deal with the manufacturer.
Specifications
Specifications
